pp108 : Redeploying Incomplete Applications using Application Deployer

Redeploying Incomplete Applications using Application Deployer
This topic describes the procedure to redeploy incomplete applications using Application Deployer.

While deploying an application, if Revert on Failure check box is not selected and the application fails to load completely, it is shown in the Deployment Overview page as Incomplete. Such applications can either be redeployed or undeployed.

  1. On CUSP > My Applications, click (Application Deployer). A Deployment Overview page is displayed.
  2. Click (Incomplete) in the Deployment Overview window. The list of applications which are not completely deployed is displayed in the Applications List section.
    Note: The count of the Incomplete applications will be displayed as zero if there are no incompletely deployed applications.
  3. You can do any of the following:
    • Redeploy the application as follows:
      1. Right-click the required application and select Deploy. An Application Deployer wizard is displayed. By default, the current version of the package is displayed. 
      2. Click Next. The application will start deploying from where it stopped earlier.
    • Undeploy the application as follows:
      1. Right-click the required application and select 'Undeploy'. An Application Undeploy wizard is displayed. 
      2. Click Next and proceed with undeploying the application package.

 

 Note: You can also rollback to a previous version of an incomplete package. In the Application Deployer wizard, click , select the version of the application package to be rolled back from the list, and click Next.The application will be rolled back to the selected version.

 

Based on your selection, the applications will be redeployed or rolled back to a previous version or undeployed.